#Kali wireshark no interfaces found install#

We specify those parameters with a transformset. After passing Main Mode, the peer will propose its IPsec Security Association (SA) to the other peer. We also define a pre-shared key for authentication with “crypto isakmp key.” command. These parameters will be offered to the other IPsec peer in IPsec Main Mode (Phase1). After achieving basic connectivity, we need to define ISAKMP proposals (SA) with “crypto isakmp policy”. First thing first, we will assign IP addresses to the interfaces and add the relevant static routes to the routing table. Step-3: Configuring IPsec_Gateway is more complex compared to Site1 and Site2. It does not require a complex design except assigning IP address to 2 interfaces and inserting the route to Site2 (2.2.2.2). Step-1: Configuring Site1 is pretty straightforward. Step-7: Start Strongswan with the command below.Ĭonfiguring the sites and the other IPsec peer All the debug logs, including ISAKMP encryption key will be stored in the charon.log file. Step-6: After basic configuration and enabling debugging, we need to set the log file path, configuring /etc/nf like below.

└─# echo 1 > /proc/sys/net/ipv4/ip_forward Step-3: Enable routing and add the Site1 and Site2 routes into the routing table with commands below and then verify them. Step-2: Add two network adapters eth1, eth2 and configure their ip addresses like below.

#Kali wireshark no interfaces found install#

Step-1: Install Strongswan with the command below. We will create a simple IPsec configuration on the Strongswan.